Ismertetés:
The EN25F10 is a 1M-bit (128K-byte) Serial Flash memory, with advanced write protection mechanisms, accessed by a high speed SPI-compatible bus. The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction.
The EN25F10 is designed to allow either single Sector at a time or full chip erase operation. The EN25F10 can be configured to protect part of the memory as the software protected mode. The device can sustain a minimum of 100K program/erase cycles on each sector.
FEATURES
* Single power supply operation
- Full voltage range: 2.7-3.6 volt
* 1 Mbit Serial Flash
- 1 M-bit/128 K-byte/512 pages
- 256 bytes per programmable page
* High performance
- 100MHz clock rate
* Low power consumption
- 5 mA typical active current
- 1 μA typical power down current
* Uniform Sector Architecture:
- 32 sectors of 4-Kbyte
- 4 blocks of 32-Kbyte
- Any sector or block can be erased individually
* Software and Hardware Write Protection:
- Write Protect all or portion of memory via software
- Enable/Disable protection with WP# pin
* High performance program/erase speed
- Page program time: 1.5ms typical
- Sector erase time: 150ms typical
- Block erase time 800ms typical
- Chip erase time: 2 Seconds typical
* Lockable 256 byte OTP security sector
* Minimum 100K endurance cycle
* Package Options
- 8 pins SOP 150mil body width
- 8 contact VDFN
- All Pb-free packages are RoHS compliant
* Industrial temperature Range
A termék bővebb angol nyelvű leírása itt megtekinthető.
|
|